Programming
117
Pro
gramming
4. Form 14, Non-Dial-in Trunks
n
Assign COS and Tenant.
n
Assign the directory number or an abbreviated dial number
which incoming calls will ring for Day Service, Night Service 1,
and Night Service 2 modes.
n
Assign a Circuit Descriptor Number (CDN) (links this form to
Form 13).
n
Assign a Trunk Name if desired. This name appears on the
consoles and on the set displays for incoming and outgoing
calls.
n
Assign a Trunk Number.
5. Form 16, Trunk Groups
n
Assign to a trunk group if outgoing.
Programming a range of Non Dial-in Trunks
The RANGE PRGRM softkey allows block programming of trunks on
the same card. You must program the first trunk in the range and then
press RANGE PRGM to copy the values to the range of trunks that you
specify. The following fields are copied from the first trunk in the range:
n
COS, TEN, DAY, N1, N2, CDN
The TK NAME and COMMENTS fields are left blank.
The trunk numbers are assigned in sequence, beginning with the first
trunk in the range. If there are trunks that are already programmed
CDE Form 14 does not accept trunk programming changes if
the T1 card or T1/E1 module is installed and the T1 link is down
but active. To make a programming change for a T1 card,
unplug the T1 card, make the programming change and then
re-insert the T1 card. To make a programming change for a
T1/E1 module, insert a Peripheral Interface Card (PIC) into the
software location (slots 5 or 6) for that T1 link, make the
programming change, and then remove the PIC from the slot to
reset the T1 link.
Содержание SX-200 EL
