10
If your ceiling is vaulted or angled ceiling. Should
refer below Angle Mounting recommended
for a vaulted or angled ceiling instruction to
installation:
Slide the remote control receiver module above
the downrod inside the hanging bracket and
firmly push into place. (Fig.11)
Fig. 11
Make the connection of both plugs extending
from the reciever module to the corresponding
connector sockets on the hanging bracket
and connector socket protruding through the
downrod extending from the motor housing
and well arrange the connection wire without
damage. (Fig.12)
Note: The plugs extending from the remote
reciever module have a designated Input
and Output , so ensure that these correctly
connected to corresponding sockets.
IMPORTANT NOTES:
Means of power supply isolator must
be incorporated in the fix wiring, in
accordance with the wiring rules.
Incorrect conductor termination will
damage the unit.
If this fan is a replacement for an existing
fan, remove the existing wall speed
controller.
Warning:Make sure the mains power is
turned OFF during this time and ensure that
the connection is secure.
LL
NN
Fig.12
Warning : All electrical connections for
installation of this ceiling fan must only be
carried out by an Licensed Electrician.
Power supply must be isolated during the
electrical installation process.
Ceiling canopy install
The hanging bracket has 2 canopy retaining
screws pre-fitted,remove only 1 of these two
screws and loosen the second screw by a few
turns only.
Slide the ceiling canopy upwards,the canopy
has a keyhole slot on one side,align this keyhole
slot with the loosened screw still retained on
the bracket and turn canopy anti-clockwise to
capture it.
Align other screw hole in canopy with the
second screw hole ( from which screw was fully
removed) on the mounting bracket and secure
canopy with second screw.
Fully tighten the two canopy retaining screws.
Slide the canopy support flange upwards,the
holes in the flange are keyhole slotted,align with
the screws protruding from the canopy , position
flange and turn anti-clockwise to secure.(Fig.13)
10° Max
