miseno MH00130CS, Инструкция по установке, использованию и уходу

Страница: 11 / 19

9
1. Measure from range top to hood bottom and mark line A.
(26” minimum from range top) .
2. Plum and mark center line.
3. Mark mounting height line B. (12” from line A)
4. Mark mounting spread from C/L on line B. (4”)
5. Fasten (2) M6x1-1/4” screws into studs on line B. Do not
fasten screws all the way. Note: wood blocking may need
to be added behind the drywall if no studs are present.
Wall anchors may also be used but check local codes
for compliance. Failure to use suitable wall anchors
and screws to hold the weight of the hood could result
in personal injury or damage to cooking sureface or
counter.
6. Hang hood onto screws and hand tighten. (Fig.A) Use the
last M6x1-1/4” screw to further secure the hood to the wall
from inside the hood.
7. Center and attach duct cover bracket to wall below ceiling or
soffi t using (2) M6x1” screws.
8. Install electrical.
9. *Install duct work and duct tape.
10. Power up hood and check for leaks around duct tape.
11. Place telescopic duct covers onto hood and extend inner
(top) duct cover upwards and secure to duct cover bracket
using (2) M4x3/8” screws.
*if using hood in recirculating mode you must secure air
diverter plate onto wall before installing duct work and duct
covers. Turn to page 10 for more details.
A
B
C/L
12"
4"
C/L
26" min
fig. A
Duct Cover Bracket
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
Cable Lock
A cable locking connector (not supplied) might
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
Installation –
Mounting the Hood