MIRKA 8991000311, Руководство по эксплуатации

Страница: 73 / 362

Further safety instructions for all operations
Kickback and related warnings
Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other accessory. Pinching
or snagging causes rapid stalling of the rotating accessory which in turn causes the uncontrolled power tool to be forced
in the direction opposite of the accessory’s rotation at the point of the binding.
For example, if an abrasive wheel is snagged or pinched by the workpiece, the edge of the wheel that is entering into
the pinch point can dig into the surface of the material causing the wheel to climb out or kick out. The wheel may either
jump toward or away from the operator, depending on direction of the wheel’s movement at the point of pinching.
Abrasive wheels may also break under these conditions.
Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can be avoided by
taking proper precautions as given below.
a. Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback
forces. Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction
during startup. The operator can control torque reactions or kickback forces, if proper precautions are taken.
b.
Never place your hand near the rotating accessory. Accessory may kickback over your hand.
c. Do not position your body in the area where power tool will move if kickback occurs. Kickback will propel
the tool in direction opposite to the wheel’s movement at the point of snagging.
d.
Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and cause loss of control or
kickback.
e. Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent kickback
and loss of control.
Additional safety instructions for polishing operations
Safety warnings specific for polishing operations
• Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely. Tuck away or
trim any loose attachment strings. Loose and spinning attachment strings can entangle your fingers or snag on the
workpiece.
Technical data
AROP-B 312NV ARP-B 300NV Mirka
®
10.8 VDC 10.8 VDC Voltage
4000 7000 rpm 1500 2200 rpm Speed
12 mm (1/2") 0 mm (0") Orbit
Ø 77 mm (3") Ø 77 mm (3") Size of backing
pad
0.89 kg (2.0 lbs) 0.87 kg (1.9 lbs) Weight (incl. bat-
tery)
Mirka BCA 108 Battery charger
100240 VAC , 5060Hz Input
< 50 min (2.5 Ah) Charging time
< 100 min (5.0 Ah)
-20 °C  80 °C (-4 °F  176 °F) Storage temperature
range
4 °C  40 °C (39 °F  104 °F) Charging temperature
191 x 102 x 86 mm
(7 1/2 x 4 x 3 3/8") Dimension
0.66 kg (1.5 lbs) Weight
Mirka® ARP-B 300NV & Mirka® AROP-B 312NV
73
en (original)