MBD-2 Operating Manual
20
15-00167, Rev 1
f.
Prior to installing the battery cover:
•
Inspect the battery cover for cracks.
•
Inspect the gasket for wear or missing segments.
g. Install the internal battery cover by positioning over the compartment and installing the
three Torx head screws. The screws are secure when the battery cover is seated and
flush with the case surface as shown below in Figure 19, Installing the Internal Battery
Cover
Figure 19: Installing the Internal Battery Cover
h. Install the main battery in accordance with 3.2.1.1, steps f-h.
6.3
C-Rings
The C-Ring is 1.9mm thick stainless steel ‘C” shaped loop which is affixed to the MBD-2 by
two insertion holes on opposite ends of the device case. The C-Rings are used for attaching
a wrist strap or other accessory. To remove and/or replace the C-Ring:
WARNING
Both detector batteries must be replaced.
WARNING
The internal battery cover must be replaced if there is evidence of damage
and/wear that would preclude protection of the internal batteries.
WARNING
•
Do not overtighten the screws as damage can occur to the battery cover and
case threads.
•
Use only the prescribed Torx T6 screw, use of screw types will damage the
threads.
•
Never use power tools to install the screws.