11 (45)
Installation
To remove the circuit board from the enclosure
1. On OpenBAS-HV-NX10P, remove the cover. On OpenBAS-HV-NX10L and OpenBAS-
HV-NX10D, remove the 4 screws and then remove the display.
2. Insert a flathead screwdriver under the tabs on the enclosure, shown in Figure 2, in order
to lift the tabs and remove the base.
Figure 2
Tabs on enclosure
Caution:
Risk of Electric Shock.
Disconnect the mains power and disconnect the
controller from all wiring before opening the enclosure.
Attention: Always hold circuit boards by the edges to prevent damage from static
electricity. Always wear an anti-static bracelet when handling circuit
boards.
!
Содержание OpenBAS-HV-NX10 Series
Страница 2: ......
Страница 6: ...6 45 List of Tables...