Miranda SER-800D, Инструкция по установке и эксплуатации

Страница: 16 / 46

SER-800D/810E - Guide to Installation and Operation
9
4 SER Accessories
4.1 SER-WSU Power Supply
The power supply SER-WSU, for 110V and 220V operation, is
used to power the SER-800D/810E. The SER-WSU provides a
regulated -5.1VDC@2.4A power source. Plug the power supply
into a wall or power bar outlet. The SER-WSU comes with two
outlet adapters; install the proper adapter for your area.
4.2 SER-CPS Centralized Power Supply Frame
Miranda's SER-CPS Centralized Power Supply Frame can power
up to 10 SER coders. A male-to-male power plug connector is
used for the connection between an SER coder and a DC output
jack. Refer to figure 4.1, DC Power connector pinout for the prop-
er pinout.
Figure 4.1 DC Power connector pinout
-5.1VDC
Ground: digital and earth
grounds connected together
Plug specifications:
Inside diameter: 2.5 mm
Outside diameter: 5.5 mm
Minimum required shaft length: 10 mm
Warning: Damage will occur to unit if power supply adapter
polarities are not respected