Spirolab
Rev.1.8
Page 47 of 60
To enter the oximetry area, press
on the main screen. If the button is not enabled it
means that your device is not equipped with the oximetry function.
WARNING
If, before starting a test, the power supply is low, the following message will appear:
Low battery
In this case, press
to exit the test, otherwise the device will start the test a few
seconds later.
If a test is interrupted for some unexpected reason, the next time the device is
turned on, the following message will appear:
WARNING
the last oximetry test was improperly interrupted
At the same time, the device will beep intermittently for 4 seconds.
The spirolab will then display the main screen.
WARNING
To avoid compromising the reliability of readings and to protect the sensor, do not
twist the sensor cable without reason or use excessive force when using,
connecting, disconnecting or putting away the oximeter sensor.
The first few seconds of a test are used for finding the strongest signal; once this has been
found, the timer resets itself and the
spirolab
starts saving data.
If the sensor is not inserted correctly, icon
transforms into
and the icon
appears alongside it.
At the same time, the
spirolab
will beep (if set to do so in the service menu).
