Page 13
Parts and Instruction Manual - R500H Rush Carpet Extractor
5. Your R500H has two cords- One for the Extractor and one for the heater. Each cord requires a separate
15AMP circuit. Connect your 50FT power cord to the twist lock pigtail on the heater (#4 on page 11).
Plug another 50ft power cord to the twist lock pigtail on the back of the machine (#6 on page 10)
6. Connect your 25ft vacuum hose to the extractor’s vacuum inlet barb (#5 on page 10)
7. Connect your vacuum and solution line to a carpet wand or Upholstery attachment
8. COMPLETE THIS STEP BEFORE TURNING HEATER ON: Turn the pump switch to the “ON”
position using the pump switch on the handle of your R500H. Pressing the solution valve trigger of your
attachment, spray water for 10-15 seconds until you have a steady flow. This ensures the heater is filled
with fluid
9. Turn heater on using the power switch (#2 on page 11) and allow up to 3 minutes for the unit to heat up.
10. The heater is ready for use once the green lamp (#3 on page 11) shuts off. Once you start cleaning, the
green lamp will turn on and off throughout your job as the thermostats automatically regulate the
temperature.
