Page 8
Parts and Instruction Manual - R500H Rush Carpet Extractor
MAINTENANCE
MAINTENANCE:
This R
00H has been engineered and built to require minimum maintenance. But like any machine, it
does require some care to keep it in optimum working condition. Careful attention to these maintenance
instructions will give you maximum operating performance and life expectancy of the machine.
CAUTION: Disconnect the power cord from the outlet before doing any clean up or maintenance
on the machine
t
Keep the machine clean. Do not allow dust to accumulate on external surfaces or near any moving
parts.
t
After every job, wipe down the surface of the machine with a clean damp cloth.
t
Inspect cord for damage. Do not use machine with a damaged cord.
PERIODIC MAINTENANCE
t
Use only chemicals safe for extractors
t
Adhere to the appropriate mix ratios for all chemicals
t
For optimal performance, it is suggested that the operator flush the system after every job or at the
end of the day.
t
Pump seals and valves may need to be replaced at the 1000 hour mark if a loss in pressure is noted
Daily:
1. Always keep the machine clean inside and out.
2. Pour 2 gallons of clean hot water in the solution tank. Turn the pump on and flush the entire system
through the wand nozzles for about a minute to pre- vent alkaline build-up.
3. Remove dirt and lint build-up inside the filter screen in the recovery tank. Lint should be cleaned off
so that air flow is not impeded.
4. Check the solution tank strainer in the solution tank. If lint has accumulated in the screen, remove
and rinse it in clear running water.
Weekly:
1. Check and clean solution filter
2. Check for obstructions in vacuum pathway
Quarterly:
1. Check pump, plumbing and fittings for lea
LT
2. Check power cords and hoses for tears
