Page 6
Parts and Instruction Manual - R500H Rush Carpet Extractor
t
All repairs must be done by an authorized MINUTEMAN repair station.
t
Do not use replacement parts other than original MINUTEMAN parts.
t
Do not allow your spray stream to remain in one fixed location as surface damage may occur.
t
Check that all spray nozzles are securely fastened. Loose nozzles could be ejected from equipment at
high speeds.
t
This is not a toy. Keep away from children.
t
Do not pull by the power or use power cord as a handle. Always unplug by grabbing the plug and
pulling, do not unplug by pulling the power cord.
t
Inspect cord for damage. Do not use damaged cords. Connect only to properly grounded outlets.
t
Keep hair, fingers, loose clothing, and body parts away from moving parts and openings.
t
Turn off all controls before disconnecting machine
t
Use caution with ejected liquid or chemicals. High pressures and temperatures could be hazardous to
nearby people or surroundings.
t
Do not run the heater dry. always make sure you have water
t
Do not expose heater to freezing temperatures.
t
Prevent burns by wearing gloves or using a barrier to remove hot quick disconnects.
t
Never leave heater or equipment unattended when connected or powered on.
t
The accessory heater was designed for use on R100H extractors for carpet, floor and upholstery
extraction applications. Any deviation from its proper use or purpose and the consequential damage
that may occur is the sole responsibility of the end user.
ELECTRICAL - 115 Volt
Model: R
00H
This machine is designed to operate on a standard 15 amp, 120 volt, 60 Hz, AC circuit. Voltages below
105 volt AC or above 125 volts AC could cause serious damage to the motor.
