- 6 -
(Fig. L)
(Fig. M)
1
2
!
USING THE PLATIC SKEWER NUT PROTECTOR
We recommend you should replace your wheel axle to the supplied quick
release skewer to avoid any fitting problem that may occur during work-
out, because our coupling is designed to fit to the supplied skewer only.
(Fig. K)
The right side coupling has a black plastic skewer nut protector (called a “Grommet”). This is to protect your
skewer from damage during use.
Minoura cannot guarantee compatibility with all makes and models of skewer, however when using your own
skewer please use the supplied grommet.
We will NOT guarantee any fitting problem or accident caused by using your own skewer on the trainer.
We will NOT guarantee any fitting problem or accident caused by using your own skewer on the trainer.
We will NOT guarantee any fitting problem or accident caused by using your own skewer on the trainer.
We will NOT guarantee any fitting problem or accident caused by using your own skewer on the trainer.
We will NOT guarantee any fitting problem or accident caused by using your own skewer on the trainer.
When you use the supplied skewer, you should remove the grommet from the coupling. It can be done by
inserting a rod or a pen to the hole (see Fig. K) and lift up the grommet.
HOW TO INSTALL THE REMOTE LEVER
You can install the remote lever on anywhere the diameter is between 22.2mm (7/8”) and 31.8mm (1-1/4”) like as
on the handlebar.
Fully loosen the knob bolt on the plastic holder until it stops then push down the bolt to open the holder.
(see Fig. L)
Place the holder onto the handlebar, shut the holder, and pull up the bolt then tighten it. (see Fig. M)
(Fig. N)
Depends on the diameter of your handlebar, you must adjust the
shim as follows;
• 22.2mm (7/8”) - 25.4mm (1”):
Install both shims.
• 28.6mm (1-1/8”):
Install either right or left side shim.
• 31.8mm (1-1/4”):
Remove both shims.
When you install the shim on the plastic holder, make sure the
direction of the shim as shown in Fig. N.
Shim
