- 5 -
!
10mm Spanner
Adapter
Fitting Bracket
Turn the micro-adjust screw located beneath the foot pedal at the rear of
the trainer until the rear tire is 2mm away from the drive roller.
(see Fig. G & H)
At this point, stop tightening the hub handle and ensure that both ends of
the skewer are securely inserted into the couplings. Finally turn the hub
handle a maximum of two more turns to ensure the bicycle is held firmly.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: Over-tightening the hub handle may cause damage to either the trainer
or your bicycle.
6
7
Press down on the foot pedal to bring the drive roller into contact with
the rear tire (see Fig. I). If the tire is compressed more than 3mm by the
roller, release the foot pedal and loosen the micro-adjust screw until the
tire is compressed by 2 - 3mm when in contact with the drive roller.
WARNING: Too much or too little contact between the tire and the roller
can cause premature tire wear and possibly damage the drive roller.
(Fig. G)
(Fig. H)
(Fig. I)
8
USING THE SMALL WHEEL ADAPTER
(Fig. J)
If you wish to use any smaller wheel sized between 24 x 1.0”
and 26 x 1.75” on the trainer, install the supplied adapter under
the Mag unit. (see Fig. J)
1
Remove two bolts which hold the Mag unit on
the fitting bracket by an M5 hex wrench. Then
the Mag unit will be removed.
2
3
Install the supplied “Z” shaped adapter on the fitting
bracket with the removed bolts.
Make sure the direction of the adapter is exactly same
as shown in Fig. J.
Install the Mag unit onto the adapter with the supplied bolts.
Be sure you should use a 10mm open spanner to tighten these bolts, not by a hex wrench.
(Required Tools: M5 hex wrench, 10mm open spanner)
