- 4 -
Insert the left side of the skewer (Q/R lever side) into the left side cou-
pling, and adjust the rotation of the coupling so the skewer lever sits
securely in the large cut-out (see Fig. E). This will prevent damage to the
skewer during use.
Hold the bike firmly by hand and turn the right side hub handle clock-
wise until the coupling comes into contact with the right side skewer
nut.
(Fig. B)
(Fig. E)
(Fig. F)
Open the frame support legs and fit the rubber feet at the correct angle so the base is in full contact with
the floor. Do NOT remove the round metal plates from inside the rubber feet when fitting. Ensure the
rubber foot caps are facing outwards as incorrect fitting may compromise the stability of the trainer.
NOTE:
If the both legs don’t touch the floor at same time and if one side of the leg is still being lifted up slightly, pull
up the leg upward strongly then place the trainer on the floor again.
Open both couplings by turning the left side knob (see Fig. B) and the
right side hub handle (see Fig. C) anti-clockwise.
Do not over-loosen the couplings, otherwise the knob or the hub handle
may become unthreaded inside the frame.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: We suggest you do not need to move the left side coupling away so
much. It should be fine to move by the center of its length, but it needs to be
adjusted depends on the hub width. (see Fig. D)
1
2
3
4
5
Apply the Mag unit to the tire by lifting up it temporally to know the
wheel position. If the tire touches either left or right side platic housing
of the Mag unit (see Fig. F), you must adjust the wheel position again by
operating both left knob and the right hub handle.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: Be sure that the left knob is NOT for tightening the axle. It is only for
positioning the wheel. Clamping wheel securely must be done by the right side
hub handle.
(Fig. C)
(Fig. D)
Left Side Knob
Right Side Hub Handle
HOW TO SETUP YOUR HYPER-MAG TRAINER
