If you wish to use the tire sized 26x1.0" or smaller,
you need to install the optional Z-shaped "Small
Wheel Adapter" between Base Plate and Mag unit to
raise up the roller height.
The direction of Z-adapter is fixed so follow the
arrow printed on the top and make sure it's pointing
toward the front (toward your bike).
If the drive roller cannot reach the tire even if you
install the adaptor, make sure you have been installed
in correct direction.
Use the original cap head bolts for the Base Plate,
and use the supplied hex head bolts for the Mag unit.
How To Use Small Wheel Adaptor (Option)
Hex Head Bolt
Cap Head Bolt
Z-Adaptor
< in case of V270 >
Required Tools:
1 x 10mm Spanner
1 x M5 Hex Wrench
- Page 8 -
Why My Remote Shifter Doesn't Work Properly?
You may have a shifting problem that you cannot set at L
or H position properly due to the lengthened inner cable.
To fix this problem, follow the steps to adjust the initial
cable tension.
1.
Set your remote shifter at "H" position and remove
the shifter from your handlebar, then straighten the
cable as much as possible.
2.
Pull out the plastic cover cap on foot of the remote
cable. (see Fig. P and R)
3.
Hold the inside adjusting screw and push it toward
the shifter, then adjust the locking nut to set the
cable tension properly. (see Fig. S)
4.
Install the cover cap again.
(Fig. Q)
(Fig. R)
(Fig. S)
(Fig. T)
