Minolta MAGICOLOR 2350, Руководство пользователя

Страница: 28 / 208

Media Types 26
Use envelopes that are
Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
Approved for laser printing
Dry
Printed on the front (address) side only
Do not use envelopes that have
Sticky flaps
Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for
sealing
Transparent windows
Too rough of a surface
Material that will melt, vaporize, offset discolor, or emit dangerous fumes
Been presealed
Labels
A sheet of labels consists of a face sheet (the printing surface), adhesive, and
a carrier sheet:
The face sheet must follow the plain paper specification.
The face sheet surface must cover the entire carrier sheet, and no
adhesive should come through on the surface.
You can print continuously with label paper. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, print one sheet at a time.
Type Check www.minolta-qms.com/support (click on Answer
Base) for currently approved media. To order approved
media, go to www.q-shop.com.
Driver Mode Thick Stock
Weight 25–43 lb bond (91–163 g/m²)
Duplexing Not supported
Note 43 lb bond (163 g/m²) is also referred to as 90 lb index stock
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500