12 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
i. With the Right Sideplate laying flat, and the CoPilot
Receiver that was just installed facing upwards,
route the yellow wire Antenna through the pegs and
grooves on the Right Sideplate. Follow the grooves
in each of the pegs.
j. Route the CoPilot Power Connection through the
bottom groove in the Right Sideplate.
k. Remove the Dust Cap from the Connection Port
located towards the back end of the exposed side of
the motor on the right side of the Mount.
l. Take the CoPilot Power Connection that comes off
of the CoPilot Receiver that is attached to the Right
Side Plate and Plug it into the Connection Port.
m. Be sure that the CoPilot Power Connection sits
comfortable between the Mount and the Right
Sideplate and can not be pinched. Reseat the
Right Sideplate.
n. Using a #2 Phillips Screwdriver, replace the two
Screws from the Right Sideplate of the Terrova mount.
Dust Cap
Dust Cap
Connection Port
Connection Port
Connection Port
Connection Port
Power Connection
Power Connection
Right Sideplate
Right Sideplate
Right Sideplate
Right Sideplate
Sideplate Screw
Sideplate Screw
CoPilot Receiver
CoPilot Receiver
Power Connection
Power Connection
Antenna
Antenna
Right Sideplate
Right Sideplate
NOTICE:
Do not apply lubricant or any type
of grease to trolling motor connectors. Make
sure that the flat sides of the Power Connection
and Connection Port align so the plugs connect
together correctly.
5
6
7
7n
6k
6l
7m