SYSTEM READY
POWER
STATUS
In the unlikely event Ulterra will not trim or stow, the following procedure will reset the motor and restore functionality:
1. Press and hold the POWER button located at the
mounting base to turn power off (green LED light will
turn off ).
2. Press the POWER button until the green LED light
illuminates.
3. Wait 3 seconds.
4. Press the POWER button 3 times within a 2 second
period.
5. Red and green LED lights will fl ash continuously and
the Ulterra will go through the following automated
sequence:
• Motor will position itself into the proper orientation
• Motor will automatically trim up to the mounting base and trim down approximately 6 inches.
• The fl ashing red LED light will turn off , and the fl ashing green LED light will become solid green.
Ulterra is now reset and fully functional.
If Ulterra does not reset, repeat the procedure. If the second attempt fails, please contact your local authorized service center or call
Minn Kota service at (800) 227-6433.
NOTE:
If the lower unit of the motor is trimmed within 6 inches of the mounting base and the boat hull is obstructing the motor’s
turning radius, manually turn the head of the motor so that the lower unit is perpendicular to the motor ramps prior to beginning this
procedure.
In the unlikely event your remote becomes non-functioning, you can
stow the Ulterra from the base of the motor by completing the following
sequence:
1. Ensure that the motor is on.
2. Press and hold the POWER button located at the mounting base for
10 seconds.
3. The red and green LEDs will flash alternately, and motor will begin
stow process.
TRIm/sTOW REsET PROCEDURE
sTOWIng fROm THE ULTERRA mOTOR
minnkotamotors.com | 31
©2015 Johnson Outdoors Marine Electronics, Inc.
ALTERnATIVE sTOWIng PROCEDUREs
