ITEM(S) NEEDED
2
#14 x 1
#16 x 1
c. Slide the Base Plate (Item #12) into the Slide Plate.
d. Place the Lockwasher (Item #16) onto the Thumb
Screw (Item #14). Secure the plates with the
Lockwasher and Thumb Screw.
#12 x 1
Installing the Slide Plate to Edge, Fortrex and Ultrex Motors
a. Take the Slide Plate (Item #10) and align the
mounting holes on the plate with the mounting holes
on the Base Extrusion. The mounting holes closest
to the short edge of the plate should face outboard.
NOTICE:
Place the stabilizer strap (if included with
your motor) between the Base Extrusion and the Outer
Plate. The strap must be located in the Relief Cut on the
motor mount or quick release failure may occur.
#2 x 6
#6 x 6
ITEM(S) NEEDED
1
Nylock Nut
Nylock Nut
Slide
Slide
Plate
Plate
Pan Head
Pan Head
Screw
Screw
Base
Base
Extrusion
Extrusion
b. Using a #3 Screwdriver, fasten the Base Extrusion
to the Slide Plate with six 1/4” x 7/8” Pan Head
Screws (Item #2) and six Nylock Nuts (Item #6).
The Screws should pass through the Base Extrusion
and Slide Plate, then be secured by a Nylock Nut.
Outboard
Outboard
Inboard
Inboard
#10 x 1
Stabilizer
Stabilizer
Strap
Strap
2d
Inboard
Inboard
Outboard
Outboard
Slide
Slide
Plate
Plate
Base Plate
Base Plate
Thumb
Thumb
Screw
Screw
Lockwasher
Lockwasher
ITEM(S) NEEDED
2
#14 x 1
#16 x 1
2d
c. Slide the Base Plate (Item #12) into the Slide Plate.
d. Place the Lockwasher (Item #16) onto the Thumb
Screw (Item #14). Secure the plates with the
Lockwasher and Thumb Screw.
Inboard
Inboard
Outboard
Outboard
Slide
Slide
Plate
Plate
Base Plate
Base Plate
Thumb
Thumb
Screw
Screw
Lockwasher
Lockwasher
#12 x 1
3 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.