Base
Base
Plate
Plate
Screw
Screw
Mounting
Mounting
Holes
Holes
Flat Washer
Flat Washer
Nylock Nut
Nylock Nut
3i
3
h. Drill through the deck of the boat using a 9/32”
Drill Bit on the marked locations.
i.
Secure the Base Plate to the deck of the boat using
six ¼ x 2¼” Screws (Item #8), six Flat Washers
(Item #4) and six Nylock Nuts (Item #6).
#8 x 6
#4 x 6
#6 x 6
ITEM(S) NEEDED
Boat
Boat
Deck
Deck
a. Take the Slide Plate with the motor attached and
slide it into the Base Plate. The Slide Plate slides
inboard from the back end of the Base Plate. Once
slid all the way forward, secure the Slide Plate to the
Base Plate using the Thumb Screw and Lockwasher.
b. Your motor is now ready to be mounted. Always
check the Thumb Screw to verify that it is tight.
NOTICE:
To help prevent
motor theft, a padlock can
be installed in the hole in
the bracket’s right corner.
Thumb
Thumb
Screw
Screw
Padlock
Padlock
Slot
Slot
Completing the Installation
1
NOTICE:
To reinstall the lift cylinder for Ultrex motors,
please review the “Installing the Gas Spring Pin” section
of the Ultrex Owner’s Manual (#2297160) online at
.
NOTICE:
To reinstall the lift cylinder for Fortrex motors,
please review the “Installing the Gas Spring Pin” section
of the Fortrex Owner’s Manual (#2287100) online at
Part #2374911
Rev K
09/20
ECN 40110
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
©2020 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
minnkotamotors.com
For warranty information, please visit