3 | minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
d. Confirm that the Gas Spring Pin is disconnected.
Please review the “Disconnect the Gas Spring”
section of these instructions if unsure.
Remove Motor From Mount
a. With the gas spring disconnected, place the motor in
the deployed position.
b. A 5/16” Allen Screw is located on the Mount. The
Screw is on the opposite end of the Mount from
the hinge. The hinge allows the Mount to stow and
deploy. Remove the 5/16” Allen Screw with a 1/4”
Allen Wrench.
c. Once the Allen Screw and Lock Washer are removed,
lift the Steering Module straight up until free from
the mount.
Allen Screw with Lock Washer
Allen Screw with Lock Washer
1
2
WARNING
Moving parts can cut or crush. The gas assist lift mechanism
is under pressure. Disconnect gas spring before removing
motor from mount. Do not engage the Pull Grip and Cable
until gas spring is disconnected.
WARNING
Moving parts can cut or crush. The gas assist lift mechanism
is under pressure. Disconnect gas spring before removing
motor from mount. Do not engage the Pull Grip and Cable
until gas spring is disconnected.
End Links
End Links
Keyways
Keyways
Steering
Steering
Module
Module
3
Pull Grip and Cable
Pull Grip and Cable
Safety
Safety
Latch
Latch
Motor Ramp
Motor Ramp
e. Press and hold the Safety Latch down towards the
Motor Ramp to the open position. With the Safety
Latch held in the open position, stow the Mount with
the Pull Grip and Cable to disengage the latch bar,
allowing the Mount to fold into a flat position.
f.
Once the Mount is in the stowed or flat position, the
Mount can be uninstalled from the deck of the boat or
a Quick Release Bracket.
2b
2c
3d