6
PROGRAMMING
PCB-001-388
REVISION A (09/2017)
1.
Locate the desktop shortcut for the Dataman IDE…
open the program.
2.
Locate and select the ‘Load Project’ op on from the shortcuts located at the top of the IDE...
3.
Navigate to network storage loca on for programming files.
As of 21/09/17 the loca on is ‘S:\Programming files\’ however this may change in the future.
Open the ‘Pan and Rotate camera’ folder, now open the ‘Board level’ folder. Open the file named…
‘PCB-001-388 rev6A analogue sonde.eprj’.
The IDE will now load the correct seMngs for the device.
4.
Ensure the correct programmer ‘Dataman-40PRO’ is connected, refer to the bo?om of the IDE…
The programmer should be ‘if this is not the case close the program & then swap the programmer.
Repeat steps 1—4.
5.
Navigate to the top of the IDE and select the menu ‘Device’. This will open a sub-menu, select ‘Program’. A new menu
will now open detailing the seMngs for programming the device.
6.
Check the seMngs match the ones shown in the screenshot above. If that is not the case make them match, however if
the seMngs do match click the ‘Yes’ bu?on located at the bo?om of the menu to begin programming.
PAGE 4
