Minelab Manticore, Инструкция по эксплуатации

Страница: 46 / 78

CONTENTS
46
Ferrous Tones
The Ferrous Tones setting allows you to set
the volume and pitch of ferrous targets�
This means that ferrous targets can be
made to sound louder or quieter, and higher
or lower pitched for a nuanced audio experience�
The defaults are set very low so that ferrous targets are
quiet and low pitched and therefore distinctly different
from loud, high pitched conductive targets�
Ferrous Pitch has a range from 1 to 50 (low‑to‑high)�
Ferrous Volume has a range from 0 (Off) to 25�
Ferrous Tones adjustment is local; only the current Search
Mode is affected by changes to this setting�
Ferrous Tones
Ferrous
Volume
Ferrous Tones in the
Settings Menu�
FERROUS VOLUME
The Ferrous Volume setting controls the loudness of
ferrous detections� This can be useful for making unwanted
ferrous detections quieter�
Adjusting Ferrous Volume
1. Navigate to Ferrous Tones:
Settings > Ferrous Tones
2. Press

/

to select Ferrous Volume then press the
Right Soft Key ( Edit) �
3. Press

/

to adjust the Volume�
In trashy or iron infested locations, set the Ferrous
Volume to be just‑audible� Next, adjust the Target
Tone setting (page 44) to increase the volume of the
Tone Regions where your preferred targets will appear�
This will emphasise them�
This way, you can hear how much ferrous trash is being
detected� If you hear lots of ferrous trash, detect more
slowly so you don't miss good targets� If you hear very
little ferrous trash, you can detect more quickly�
FERROUS PITCH
The Ferrous Pitch setting controls the pitch of ferrous
detections� This can be useful for differentiating good
targets from bad targets using the audio alone�
Adjusting Ferrous Pitch
1.
Navigate to Ferrous Tones:
Settings > Ferrous Tones
2.
Press  /  to select Ferrous Pitch , then press the
Right Soft Key ( Edit) �
3.
Press  /  to adjust the Pitch�