Minebea Intec IS16EDE-H, Инструкция по установке и эксплуатации

Страница: 10 / 40

10 Installation and Operating Instructions IS16/34/64EDE
Installation Instructions
General Instructions for Integration into Conveyor Systems
The IS weighing platform is suitable for installation in conveyor systems.
Follow the general instructions given below and refer to the “Dimensions (Scale
Drawings)” to meet the requirements for such installation.
– Any moving or rotating parts intended to be permanently attached to the
load plate must be designed so that they cannot negatively affect the accuracy
of weighing results. For example, rotating mechanisms must be properly
balanced.
– The load plate must be clear on all sides so that any parts or any dirt that
falls will not create a connection between the weighing platform and any
permanently mounted preload components.
– Any cables or tubing between the weighing platform and other equipment
must not apply any force to the weighing platform. Make sure that cables do not
touch the load plate.
– Do not install the weighing platform in a conveyor system located in a Zone
2 or 22 hazardous area/location ( special version ).
Preload Range (Zero-setting Range)
The weight of components that are permanently installed on the weighing
platform is called “preload.” The weighing platform electrically compensates for
this preload so that the entire weighing range is available and the platform can
be zeroed and can also be calibrated/adjusted using external weights. Higher
preloads may result in a reduction in the maximum weighing capacity. The
maximum preload that can be compensated for depends on the specifications
configured (please see the “Specifications Chart”).
The preload must be set before the platform is verified for use in legal
metrology. The components for integration into a conveyor must be installed on
the weighing platform before you connect the platform to the power supply.
Configuring the Weighing Platform
If you have a standard-model weighing platform, you can adapt it for specific
requirements such as weighing in international weight units, use under
unfavorable ambient conditions, or further processing of weighing results, for
example. If your weighing platform is to be verified for use in legal metrology,
one weight unit must be selected before verification, and cannot be changed
after verification has been performed.
You can customize the weighing platform (weighing module) via the
Configuration menu
using a connected display and control unit, or using a connected computer with
special
Minebea Intec configuration software (see accessories).
The configuration options for your weighing platform are listed in the
“Specifications Chart” on the following pages.