Minarik MM21051C, Руководство пользователя

Страница: 36 / 56

30 Calibration
TORQUE
Warning
Although TORQUE LIMIT is set to 120% of motor nameplate
current rating, continuous operation beyond that rating may
damage the motor. If you intend to operate beyond the rating,
contact your Minarik representative for assistance.
The TORQUE setting determines the maximum armature current
output of the drive. It is factory set at 120% of rated motor current.
Recalibrate the TORQUE setting when using a lower horsepower
motor. Refer to the recommended TORQUE settings below, or
recalibrate using the following procedure:
1. With the power disconnected from the drive, connect a DC
ammeter (0-15 A minimum scale) in series with the armature.
2. Set the TORQUE trimpot to minimum (full CCW).
3. Lock the motor armature. Be sure that the motor is firmly
mounted.
4. Connect power to the drive. The motor should remain stopped.
5. Set the speed adjust potentiometer to maximum (full CW).
6. Adjust the TORQUE trimpot CW slowly until the armature current
is 120% of motor rated armature current.
7. Set the speed adjust potentiometer to minimum.
8. Remove power from the drive.
9. Remove the stall and ammeter from the motor.