![background image](http://html1.mh-extra.com/html/milwaukee/mw105-max/mw105-max_instruction-manual_1798930014.webp)
14
MW105 & MW106 Portable Meters
6. GENERAL OPERATIONS
6.1. BATTERY MANAGEMENT & REPLACEMENT
The meters are supplied with 3 x 1.5V alkaline AA batteries and
equipped with Battery Error Prevention System (BEPS) feature,
which turns the meter off after 10 minutes of non-use (see SETUP
OPTIONS, Auto Off section).
At power on, the instruments perform an auto-diagnostic test and
all LCD segments are displayed for a few seconds.
Use
keys to check the battery percentage.
To replace the batteries
1. Turn the meter off.
2. Remove the 4 screws on the back of the meter to open the
battery compartment.
3. Remove the old batteries.
4. Insert the three new 1.5V AA batteries while paying attention
to their polarity.
5. Close the battery compartment using the 4 screws.
6.2. CONNECTING THE PROBE
With the meter off, connect the
MW906BR/1
probe’s connectors
to the BNC and RCA sockets on the top of the meter.
Note: When the temperature sensor is not connected,
temperature can be set manually by pressing CAL/EDIT then
using
keys. See SETUP OPTIONS, MTC Mode section.