4
ASSEMBLY
Removing/Installing the Filter
Pick-Up/Blower
The vacuum can be used for debris pick-up or as a
blower, depending on the port used.
1.
2.
Installing/Removing the Accessories
To install the nozzles, hoses or extensions, push
the accessory onto the vacuum inlet.
1
1
2
3
4
5
6
7
7
8
9
10
11
1. Battery compartment
latches
2. Midframe
3. Tank
4. Tank latches (front and
back)
5. Vacuum inlet
6. Blower port
7. Accessory storage
areas
8. Intake port
9. Battery bay
10. Switch
11. Fuel gauge
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack out of battery bay.
FUNCTIONAL DESCRIPTION
WARNING
Recharge only with the charger
specified for the battery. For
specific charging instructions, read the
operator’s manual supplied with your charger
and battery.
CAUTION
Keep filter clean. Efficiency of the
vacuum is largely dependent on
the filter. A dirty filter will reduce the air flow
and overall efficiency of the system. Do not
clean with water. Remove from tank and tap
clean.
WARNING
To reduce the risk of injury,
always remove the battery pack
before removing the battery pack before
removing the tank.
To
insert
the battery, slide the pack into battery bay.
Make sure it latches securely into place.
Use the filter for dry pickup only.
Remove the battery pack. Close and latch the
battery compartment.
Release the tank latches and lift off the motor
housing. Place it upside down on a flat surface.
To
remove
the filter, turn it 13 mm
counterclockwise and pull it off of the midframe
base/float cage.
Empty all debris from the tank.
NOTE:
When applicable, adhere to jobsite
guidelines pertaining to the disposal of silica
dust.
To
install
the filter, slide it over the float cage.
Lineup the filter tabs with the motor housing
notches and turn it 13 mm clockwise to lock in
place.
Reinstall the tank and secure both latches.
1.
2.
3.
4.
5.
6.
WARNING
Only use accessories specifically
recommended for the product.
Others may be hazardous.
To use as a
blower
, insert the large end of hose
into the blower port of the midframe, lining up
the tabs on the hose with the notches in the port.
Twist to secure and form a tight fit.
For the debris
pick-up
, insert the large end of
the hose into the intake port of the motor
housing, lining up the tabs on the hose with the
notches in the port. Twist to secure and form a
Содержание M12 Fuel
Страница 2: ......