Milvus Robotics SEIT 500, Руководство пользователя

Страница: 43 / 62

43 | P a g e
Version 2.3 (05/2021) EN
User Manual for SEIT 500
•
Setting Up The Charger
After MR AutoC – 5 00’s setup is prepared, one must follow the following procedures to initialize the
docking station.
➢
Plug connection cable’s one end into “ 110/220V AC socket ” (See page 35) and plug the other
end into the 110/220V AC grid. ( See Figure 5.19 for connection cable )
➢
Turn “ On/off switch ” (See page 35) in CW direction to initialize MR AutoC – 500.
➢
“ Led indicator ” (See page 35) of MR AutoC – 500 starts to show sliding effect in white color,
which means it is booting.
➢
When led indicator turns solid white, it is ready to charge SEIT 500.
By turning “ On/off switch ” (See page 35) in CCW direction, one may turn off the docking station.
DANGER
Risk of injury

ELECTRICAL SHOCK HAZARD. DO NOT TOUCH BOTH PINS WHILE ENERGIZED.
•
Charging Manually
Either SEIT 500 ’s battery is charged manually via charging pads or directly via anderson battery
connector.
To charge via anderson battery connector, one must follow the following procedure;
➢
Plug the connection cable’s one end into “ anderson charge connector ” (See page 35)
and plug the other end int o “ manual charge connector “ (See page 26). (See Figure 5.18
for supplied connection cable).
To charge via charging pads, one must “ drive the SEIT 500 manually ” and draw it up to MR
AutoC – 500 as in the Figure 5.17. (See page 30 to check manual drive).
•
Charging Automatically
To charge automatically, please refer to software interface part on this manual.