General installation and maintenance instructions
HOSPITAIR PACK S (MV) - 11 bar
Manual N° 520003 version 5
12/2016
Page 16/17
Guidance and manufacturer’s declaration – electromagnetic immunity - for ME equipment and ME systems that are not life-
supporting
The units
with PROCOM2 automate is intended for use in the electromagnetic environment specified below. The customer or the user
of the units
with PROCOM2 automate should assure that it is used in such an electromagnetic environment.
Immunity test
IEC 60601 test level
Compliance level
Electromagnetic environment
–
guidance
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
3 Vrms
150 kHz to 80 MHz
3 V/m
80 MHz to 2,5 GHz
3 Vrms
3 V/m
Portable and mobile RF communications
equipment should be used no closer to any part of
the units
with PROCOM2 automate, including
cables, than the recommended separation
distance calculated from the equation applicable
to the frequency of the transmitter.
Recommended separation distance
d =
1.16
√
P
d =
1.16
√
P
de 80 MHz à 800 MHz
d =
2.33
√
P
de 800 MHz à 2,5 GHz
where
P
is the maximum output power rating of
the transmitter in watts (W) according to the
transmitter manufacturer and
d
is the
recommended separation distance in meters (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey (1)
should be less than the compliance level in each
frequency range. (2)
Interference may occur in the vicinity of equipment
marked with the following symbol:
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
(1) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the
electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field
strength in the location in which the units
with PROCOM2 automate is used exceeds the applicable RF compliance level above the
units
with PROCOM2 automate should be observed to verify normal operation. If abnormal performance is observed, additional
measures may be necessary, such as re-orienting or relocating the units
with PROCOM2 automate.
(2) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
