Milnor 36030, Руководство по установке

Страница: 27 / 49

#& # $" #"6hh GQcXUb 5hdbQSd_b 9^cdQ\\QdY_^
@5<<5B9> =9<>?B 3?B@?B1D9?>
2. Never push, pull, lift, jack, or exert pressure on any components that protrude from the
machine frame (shell front, door, electric boxes, controls, guards, conduits, conveyors,
piping, valves, drains, vents, tilt frames, etc.).
3. Do not pull on door conduit to help move the machine as the door switch may require
readjustment.
"
BXcTAT`dXaT\T]cb
"
B_PRTAT`dXaT\T]c
1. All openings and corridors through which equipment must pass during installation must be
large enough to accommodate the width and the height of the machine as shown on the
dimensional drawings. It is occasionally possible to reduce the overall dimensions by
removing piping or other special modifications. Consult Milnor for additional information.
2. Sufficient clearance must be provided for normal operation and maintenance procedures.
"!
>_TaPcX^]P[AT`dXaT\T]cb
1. Allow sufficient ventilation for the heat and vapors of normal operation to dissipate.
2. Provide easy access to controls. Operators must be able to view all status lights and reach all
controls associated with the machine (e.g., electrical power connections, water and steam
shutoffs, etc.)
""
5^d]SPcX^]AT`dXaT\T]c
—The floor and/or all other support components must have
sufficient strength and rigidity with due consideration for the natural or resonant frequency
thereof to withstand the fully loaded weight of the machine, including the wet goods and any
repeated sinusoidal (rotating) forces generated during its operation. Determining the suitability of
floors, foundations, and other supporting structures normally requires analysis by a qualified
structural engineer.
Figure 3: Vibration warning
20DC8>= ! ) <PRWX]T SP\PVT WPiPaS—Improperly installed suspension type machines
can “walk” out of position during extract (Figure 3), endangering personnel and damaging
equipment.
• Roughen floor. Install anchor bolts and grout under all base pads to prevent “teeter-totter”
and sideways movement.
• Remove shipping restraints after machine is in place. Failure to remove all restraints
(usually painted red) will cause malfunctions and damage. Restraints may be located
behind access covers. These include, but are not limited to:
• Cylinder hold-down bolts, brackets, straps and/or blocking. Replace all fasteners which
23