Millipore NovAseptic GMP ATEX, Инструкция по установке и эксплуатации

Страница: 29 / 45

!
Cleaning and Sterilizing Procedures
Cleaning in Place (CIP)
GMP mixers are designed for CIP using any of the following processes: sprayball,
rotary jethead, or submerged.
Sprayball and Rotary Jethead Cleaning
Start the liquid circulation through the sprayball or jethead before starting the mixer
to ensure lubrication of the bearing.
NOTE:
Recommended maximum speed of the mixing head •
is 100 rpm.
Ensure that the bearings are continuously lubricated. •
Stop the mixer before turning off the sprayball/ •
jethead function.
Add liquid before running the mixer after cleaning to •
ensure lubrication of the bearings.
Submerged Cleaning
Introduce enough cleaning or rinsing liquid into the vessel to cover the mixing head
and the male bearing.
NOTE:
Avoid vortex. •
Add liquid before running the mixer after cleaning to ensure lubrication of the •
bearings.
Magnetic Particles •
a. If presence of magnetic particles is suspected, remove the mixing head. •
Remove the particles and reinstall the mixing head. (Refer to Male Bearing
Installation, Mixing Head Installation, and Drive Unit Installation in this
manual.)
b. • Magnetic particles are not removed from the mixing head during CIP; they
must be removed manually or by alternative cleaning. Magnetic particles can
cause corrosion and damage. They can also cause a higher torque, which may
cause the mixing head to decouple and severely damage the vessel.
28 www.millipore.com