Miller Trailblazer 275, Руководство пользователя

Страница: 51 / 64

Complete Parts List is available at www.MillerWelds.com
OM-249 795 Page 47
Trouble Remedy
Engine starts but stops when Engine
Control switch returns to Auto Speed
position.
Check oil level (see Section 5-5). Low oil pressure shutdown stops engine if oil pressure is too low.
Engine starts but stops when Engine
Control switch returns to Auto Speed
position (Continued).
Use correct grade oil for operating temperature. (see Section 8-1).
Have Factory Authorized Service Agent check low oil pressure shutdown switch S5.
Battery discharges between uses. Place Engine Control switch in Off position when unit is not running.
Clean top of battery with baking soda and water solution; rinse with clear water.
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator according to engine manual.
Engine stopped during normal
operation.
Check fuel level (see Section 5-5).
Check oil level (see Section 5-5). Low oil pressure shutdown stops engine if oil pressure is too low.
Oil level too high reduces capacity of the fuel pump (carbureted engines only).
Have Factory Authorized Service Agent check fuel shutoff solenoid FS1 according to engine manual (car-
bureted engines only).
Have Factory Authorized Service Agent check low oil pressure shutdown switch S5.
Engine does not return to idle speed. Be sure Engine Control switch S2 is in Auto Speed position.
Remove all weld and generator power loads.
Turn off remote device connected to Remote receptacle RC4 (see Section 5-11).
Have Factory Authorized Service Agent check circuit board PC1 and current transformer CT1.
During operation in near freezing tem-
peratures, engine starts and goes to
idle but stalls after a few minutes.
Treat fuel with isopropyl alcohol de-icer product.
Place Engine Control switch in the Run position until unit has been in operation and loaded for a peri-
od of time.
During operation in severe cold weath-
er, engine starts and goes to idle but
stalls after a few minutes.
Install engine manufacturer’s kit for cold-weather operation (carbureted engines only).