Miller TM-4414K, Техническое руководство

Страница: 19 / 36

TM-4414 Page 15
Belt/Hydraulic-Drive Generator
6-4. Power Board PC1 Testing Information
803 236 / Ref. 209 400
Be sure plugs are secure before
testing. See Section 6-5 for specific
values during testing.
1
Power Board PC1
2 Receptacle RC31
.
Receptacle RC31 was pre-
viously labeled RC14.
Test Equipment Needed:
2
1
6-5. Power Board PC1 Test Point Values
PC1 Voltage Readings
a) Tolerance −
±
10% unless
specified
b) Condition − no load; generator
running at 3000 (50 Hz) or 3600
rpm (60 Hz)
c) Reference − to circuit common
(RC31-7) unless noted
Receptacle Pin Value
RC31 1 Pulse Width Modulation (PWM) Signal: 0 to +15 volts DC at no load; voltage increases with genera-
tor load
2 Shutdown Signal: +12 volts DC when shutdown is latched; 0 volts DC when shutdown is not latched
3 +12 volts DC
4 Revolving field (rotor): +25 volts DC at no load with respect to RC31-6; +75 volts DC at full load with
respect to RC31-6
5 Not used
6 Revolving field (rotor): +25 volts DC at no load with respect to RC31-4; +75 volts DC at full load with
respect to RC31-4
7 Circuit common
8 Exciter: 150 volts AC with respect to RC31-9
9 Exciter: 150 volts AC with respect to RC31-8