Miller Maxstar 140, Руководство пользователя

Страница: 20 / 44

OM-2224 Page 16
2-12. Installing 230 Volts Ac Input Power Cord
Y
Disconnect input power plug from
receptacle before installing differ-
ent input power cord.
Remove the case by removing the two top
handle screws and sliding case up and off.
Disconnect case grounding wire when re-
moving case.
1 Input Power Cord
Remove knob from Power Switch (4). Note
how knob goes onto shaft.
Remove screws holding Power Switch in
place, and pull switch out toward inside of
unit.
Loosen strain relief clamp, and push sever-
al inches of power cord into unit.
Mark location of switch terminals where
black and white leads are connected, and
note location of ground lead. Disconnect
leads from ground terminal and switch.
2 Black Switch Lead
3 Rear Panel
4 Power Switch
Pull out power cord from rear of unit.
5 Case Grounding Lead
6 White Lead
7 Green Ground Lead
Insert new power cord through strain relief,
and push an extra inch into unit.
Connect ground lead and black and white
leads to marked locations. Double-check all
connections.
Reinstall Power Switch onto rear panel. Pull
power cord back through strain relief until
leads are properly dressed in unit. Tighten
clamp.
Reinstall case and reconnect case ground-
ing lead during assembly.
DP-00333
5
4
6
2
1
3
7
Tools Needed: