Miller 059015051, Руководство пользователя

Страница: 25 / 60

OM-287348 Page 19
PURGE INCH
4-8. Changing Drive Rolls And Wire Inlet Guide
956172373_4-A
1 Drive Roll Securing Screw
2 Drive
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
The drive roll consists of two
different sized grooves. The
stamped markings on the end
surface of the drive roll refers to the
groove on the opposite side of the
drive roll. The groove closest to the
motor shaft is the proper groove to
thread.
3
Inlet Wire Guide
Slide tip as close to drive rolls as
possible without touching.
4
Pressure Roll
Allows wire to be pressed on the
drive roll. Pressure is adjusted by
adjustment knob.
Pressure rolls can be replaced
with drive rolls to make 4 drive
roll system.
4
1/4 in.
3
4
1
2