Miller Electric SuitCase X-TREME 12VS, Руководство пользователя

Страница: 20 / 44

OM-252 203 Page 16
5-3. Connecting Welding Gun And Voltage Sensing Clamp
256 617-A / 256 619-A
!
Turn Off wire feeder and
welding power source.
Stop engine on welding
generator.
!
Weld voltage is present at
voltage sensing clamp
when wire feeder and
welding power source are
on. This condition exists
even if wire feeder lights
and meters are off.
Turn off wire feeder or
welding power source be-
fore handling or moving
voltage sensing clamp.
1 Gun Securing Knob
2 Gun Block
3 Gun Power Pin
4 Power Pin Groove
5 Gun Locking Tab
Loosen gun securing knob, insert
gun power pin into gun block. Po-
sition power pin as close as pos-
sible to drive rolls without touch-
ing. Align the gun power pin
groove with the gun locking tab.
Tighten gun securing knob.
If the gun power pin does not
have a groove, loosen knob to ro-
tate the gun locking tab 180 de-
grees. This prevents the the gun
locking tab from interfering with
the gun power pin when inserted
into the gun block. Insert the gun
power pin into the gun block. Pos-
ition power pin as close as pos-
sible to drive rolls without touch-
ing them. Tighten gun securing
knob.
6 Gun Trigger Plug
7 Gun Trigger Receptacle
Connect gun trigger plug to gun
trigger receptacle.
See Section 6-3 to make wire
speed dual schedule connec-
tions to gun trigger receptacle.
8 Voltage Sensing Clamp
Connect voltage sensing clamp
to workpiece.
3
6
7
Internal Side View
8
Gun Locking Tab In Place
Gun Locking Tab Out Of Place
5
5
4
2
1