Millcreek 57G, Руководство оператора

Страница: 37 / 38

Operator's Manual: Millcreek 57G & 77G Ground Drive Spreaders
B-5
1. Refer to the Safety Shields & Guards drawing, Appendix A . Remove the Left Rear Guard
(items #6, 8, 19) to accommodate the installation of the fines pan mounting bracket.
2. Refer to the Figure B2 . Install the lefthand (LH) fines pan mounting bracket (item #5) on the left rear
of the spreader box, using the hardware provided.
3. Install the lever (item #6) onto the LH mounting bracket, assembling the hardware (provided) in the
following order:
(a) Install the 3/8 x 1-1/2 carriage bolt (item #13) through the side sheet of the spreader box and
the LH mounting bracket.
(b) Assemble the spacer (item #7) and the 3/4 SAE washer (item #9) onto the carriage bolt.
(c) Hook the spring (item #8) onto the LH mounting bracket and also onto the lever (item #6) .
(d) Install the lever onto the carriage bolt/spacer assembly.
(e) Install the 3/8 flat washer
(item #10) and 3/8 center lock nut (item #11) onto the lever.
4. Open the rear shield door on the right rear side of the spreader box. Install the righthand (RH) fines pan
mounting bracket
(item #4) on the right rear of the spreader box, using the hardware provided.
NOTE: The 3/8 x 3/4 carriage bolt (item #15) is installed from the inside through the back shield.
When assembly of the RH mounting bracket is complete, close the rear shield door and fasten the strap.
5. Assemble item #'s 1, 2, and 3 as shown in Figure B2 to form the fines pan.
6. Mount the fines pan to the LH/RH mounting brackets, using the hardware provided.
7. Set the fines pan for operation by stepping or pushing forward on the kick plate; doing so engages the
spring (attached to the lever). Note that the knob on the fines pan should fit into the notch cutout on the
lever.
8. To open the fines pan for operation, pull front on the lever (i.e. towards the tractor).
Assembling the Fines Pan on the Spreader