EasyCUT
MM148-001
– Operator Manual
22
5.2. Procedure for EasyCUT decontamination and cleaning
Please follow the instructions below on how to carry out a correct cleaning and decontamination procedure.
5.2.1. Materials and reagents
Please find below a list of materials that make up the EasyCUT instrument and the relevant reagents:
5.2.2. Procedure
For further information, please contact our specialists at:
•
Spray the detergent, compatible with the material to decontaminate and clean, on a paper towel and mop
it on the concerned area
•
Dry with adsorbent paper or a clean cloth.
On completion of the decontamination/cleaning operations, wait at least half an hour
before connecting the power supply cable.
Materials
Reagents
Tips
Stainless steel (base of the
EasyCUT)
Never
use
aggressive
detergents, worse if they contain
hydrochloric acid (commercial
muriatic), ammonia, caustic soda
or bleach.
Do not use detergents containing
chlorine
or
its
composed
derivatives
Never use abrasive sponges. Do not
lave steel in contact with steel wool or
other metal objects that can contain or
release oxidized particles. Do not place
objects exposed to high temperatures
for long periods.
White covering (support arm
and housing of the ionizing
bar)
Do
not
use
solvents,
hydrocarbons and alcohol-based
detergents.
Never use abrasive sponges.
After cleaning with detergent, clean
with a cloth moistened with water.
Plastics (air filter and knobs
area)
Do
not
use
solvents,
hydrocarbons and alcohol-based
detergents.
Never use abrasive sponges.
After cleaning with detergent, clean
with a cloth moistened with water.
USE REAGENTS FOLLOWING THE INSTRUCTIONS PROVIDED ABOVE.
In case of doubts please contact:
Do not remove the side panels of the unit during the cleaning operations.
For decontamination and cleaning do not use procedures other than that explained in
this chapter.
Before every operation disconnect the power supply. Do not use direct or high-pressure
water to clean the instrument.
Never spray directly detergents on the instrument, as its operation could be
compromised.
Содержание EasyCUT
