7
4”
(102 mm)
total
insulation
Cut out insulation
for top vent installation
Pull forward to expose
width of 5”
b) Fit the rear base support under the rear of the
appliance attaching it to the appliance back
panel with 2 x 3/8” thread cutting (pointed end)
screws.
c) Fit the front plinth under the appliance front with
2 thread forming screws.
6. Install top insulation layer. For top vent outlet
appliances, cut out a circle at the center of the
insulation layer for the vent collar. Place the
insulation layer on top of the appliance case inboard
of the stand-off spacers.
Warning: Failure to install the insulation layer
may cause a
fi
re hazard and voids warranty.
7. If the hooks have been shipped loose with the cast
front,
fi
x them to the front at its top corners.
8. Install the barrier screen by pushing in the bottom
fi
rst to hook the clips to the frame, sliding it down
behind the fender and pushing the top in so the clips
snap into place.
space between
the edge of screen
and hook is larger
at the top than at
the bottom
top
bottom
front view
