Miles Industries 541BPC, Инструкция по установке и эксплуатации

Страница: 2 / 18

2
Casting Tolerances
Due to the nature of cast iron, dimensional consistency
may vary from one unit to the next and some variation
in surface
fi nish and fl atness is to be expected. We
have done our best to control and make allowance for
this; however some variation is inevitable.
Applications
The Valor model 530 heater with the 541BPC Bolero
Front comes ready for installation as a zero clearance
unit into combustible type framing, without need for a
separate zero clearance kit. The 530 installed without
the standard zero clearance stand-off spacers may also
be installed into existing solid-fuel burning
fi replaces
provided space and local codes permit.
Hearth Requirements
A 7/8” high plinth is supplied to raise the heater and
ensure a base at the proper height for the cast front to
sit on regardless of
fl oor fi nish height. If not using the
plinth supplied, you MUST make allowance for fl oor
fi nish and raise (shim) the heater up so the bottom
of the heater sits at the fi nished fl oor/hearth height,
otherwise, the cast front will not sit at the proper height.
A
non-combustible hearth is not required in front of this
appliance.
Kit Contents
1 Cast Frame Assembly fi tted
with Barrier Screen
1 Top Baf fl e
2 Mounting Hooks
1 Framing Plate
1 Plinth
1 Rear Base Support
1 ZC Stand-off LH
1 ZC Stand-off RH
1 Insulation Layer
1 Pack of screws
Floor Requirements
The 530 heater is approved for installation directly
on any combustible material
other than soft fl ooring
material such as carpet or vinyl.
Mantel Requirements
The 541BPC Bolero Front may be installed with
combustible mantels provided clearances are
maintained as indicated in the Dimensions and
Clearances, and Framing diagrams below and on
the following page. Be aware that although safe,
some combustible materials and
fi nishes at the
listed clearances may, over time, discolor, warp, or
show cracks. Care should be taken when choosing
materials—consult your
fi replace dealer.
Insulation
Layer
Stand-offs (2)
Top Baffle
Hooks
Cast Front
Barrier Screen
Framing Plate
w/brackets
Plinth
Rear Base
Support