6
Installation
1. Fit the top baf
fl
e under the top panel of the
appliance case. Secure with 2 thread forming
screws.
2. Fit the stand-off spacers. The stand-off spacers for
these installations are supplied
fl
at. These spacers
are left and right handed.
! Warning: Failure to install the stand-off spacers
may result in a
fi
re hazard.
a) Remove the 2 screws near each of the rear top
corners of the appliance and the 2 screws near
the rear top of each side.
b) Bend the spacers as shown.
c) Screw the spacers to the rear of the appliance
using the screws just removed.
d) Bend the side wings of the spacers to align the 2
holes in each spacer with those in the appliance
sides. Secure the spacers using the screws just
removed.
Install top baffle
offsetting
downwards
Heater
3. Mount the framing plate to the appliance.
4. Secure the framing
plate and brackets
to the sides of the
appliance case with
4 thread cutting
screws supplied.
Screw from the
outside through the
access holes in the
framing plate.
Note: There are
alternate methods of
fi
nishing around the
framing plate—either
leaving it exposed
or recessing it and
covering it up with
the wall
fi
nish. See
page 4.
5. Install plinth and rear base support below
fi
rebox
(optional).
The purpose of the plinth is to allow the appliance
to be placed on a rough sub
fl
oor, such as plywood,
without regard for the additional thickness of
fl
oor
fi
nishes as the appliance bottom must otherwise be
placed at the
fi
nished hearth height or the front trims
will not
fi
t on the appliance properly.
a) Detach the burner module from the appliance by
removing its 11 screws.