The DLM-080 FUTURE Digital Recorder – User’s Manual
26.11.2004
5
Keys on the console are arranged in the following keypads :
• the status block -1- with the following functions :
• real-time display 1.1
• function keys 1.2 with signal diodes 1.3
• parameter value increase / decrease keys 2.5
• 8 measurement channel status keypads -2- with the following functions :
• read out / set value display 2.1
• display field showing the measure of a physical value being measured 2.3
• function keys with signal diodes 2.4
• parameter value increasing / lowering keys 2.5
All information as regards working mode of the DLM-080 Recorder (values of preset and
read out parameters, equipment ON / OFF signalling, etc.) is displayed on digital displays
and by diodes.
It is necessary to press proper keys in order to save data in the DLM-080 Recorder
memory, correct data and call required controller functions.
3.
THE DLM-080 RECORDER CONFIGURATION
Immediately after turning the Recorder on all of its displays will become active, and then,
after approximately 3 sec. the Recorder will switch to the working mode and execute
operations according to preset configuration.
In order to ensure that the Recorder work complies with user’s guidelines, the following
configuration operations must be carried out :
• set (check) the real-time clock readout
(the SET CLOCK mode)
• set (check) data setting in the SETUP memory (the SETUP mode)
• scale (check) readouts on measurement channels (the SERVICE [
SERWIS
] mode)
• set (check) displaying of dimension of measured physical values (the DIMENSION
[
WYMIAR
] mode)
3.1
SPECIAL FUNCTIONS (RECORDER CONFIGURATION)
In order to modify / initiate settings of the Recorder configuration parameters, whole
range of special functions has been introduced. They permit to carry out the above-
mentioned operations.
Special functions will be available after carrying out of the following steps :
