MikroKopter ARF OktoXL, Инструкция по эксплуатации

Страница: 31 / 59

Step 9: Test motors individually
To test the motors the propellers should not be mounted.
The motors rotate during the test and it can cause injury!
With the KopterTool the motors can be tested individually for their function and rotation direction.
Important : To open the motor test it is
necessary to click on the button „ ->FlightCtrl “
before.
Another tab „ Motortest “ will appear. By
clicking on this tab the dialog for the motor test
will open.
First activate the motor test feature. That will
be done by setting the check mark for
„
Motortest active“ .
Now you can select motor „ Address“ and
power the motor using the slider.
After finishing the motor test make sure you
deactivate the motor test.
(Uncheck „
Motortest active“ box)
Step 10: Test Gyroscopes
The ARF-MikroKopter is controlled by different sensors. You can check the function of the sensors „ACC“ and „Gyro“ in
the KopterTool.
Important : To be able to check the sensors
you need to click on the button „ ->FlightCtrl “
before.
Please click the tab „Scope“ and choose the
following sensors:
–
AngleRoll
–
ACCRoll
–
AngleNick
–
ACCNick
–
GyroYaw
With a „Click“ on the button „ Start “ the scope
will start.
If you move now the ARF-Mikrokopter over
the Nick-, Roll- and Yaw-axis you will see the
function of the Gyroscopes and the ACC.
Here the lines for:
„AngleRoll“/„ACCRoll“ and
„AngleNick“/ACCNick“
should be close together.
If the lines are running very far apart the gyroscopes should be re-calibrated.
(See chapter „
Calibration “ Pg. 28)
HiSystems GmbH Page 27
info
info
!