7
EasyARM v6
MikroElektronika
page
2. Connecting EasyARM v6 to a PC
The
EasyARM v6
development system comes with the mikroBoard for ARM provided with a USB connector. This
connector enables the development system to be connected to a PC. It is also possible to provide the system with
the 5V power supply voltage from the PC via this connector. The mikroBoard for ARM may be used as a stand-alone
device. When connecting the mikroBoard for ARM card to the development system, it is necessary to remove jumper
marked STANDALONE. For more information on the mikroBoard for ARM, refer to the relevant manual.
In addition to the mikroBoard for ARM, the development system can also be connected to a PC via USB UART 1 or
USB UART2 module supplied on the development system or via a USB connector used for USB communication. It’s
also possible to connect development system via RS-232 port.
Figure 2-1
: Connecting the development system to a PC
Figure 2-2
: mikroBoard for ARM
1
2
