16
Limited One Year Warranty
Nortek Security & Control (NSC) gate opener accessories are warranted by the manufacturer against defects in workmanship for a period of one (1) year from the date of purchase, provided
recommended installation procedures have been followed .
In the case of product failure due to defective material or manufacturer workmanship within the one (1) year warranty period, the accessory will be repaired or replaced (at the manufacturer’s option) at
no charge to the customer, if returned freight prepaid to Nortek Security & Control . IMPORTANT: Call 850/575-4144 or fax 850/575-8950 for a Return Goods Authorization (RGA) number before returning
goods to factory . Products received at the factory without an RGA will not be accepted . Replacement or repaired parts are covered by this warranty for the remainder of the one (1) year warranty period .
NSC will pay the shipping charges for return to the owner of items repaired .
The manufacturer will not be responsible for any charges or damages incurred in the removal of the defective parts for repair, or for the re-installation of those parts after repair . This warranty shall be
considered void if damage to the product(s) was due to improper installation or use, connection to an improper power source, tampering, or if damage was caused by lightning, wind, fire, flood, insects,
or other natural agent .
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state . This warranty is in lieu of all other warranties, expressed or implied .
NOTE:
Verification
of the warranty period requires copies of receipts or other proof of purchase . Please retain those records .
Hole Template for Mounting the Base Unit
FCC WARNING
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment .
NOTICE: This device complies with part 15 of the FCC rules and with Industry Canada license-exempt RSS standard(s) . Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operationof the device .
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence . L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement .
However, there is no guarantee that interference will not occur in particular installations . If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or replace the receiver antenna .
• Increase the separation between the equipment and the receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help .
©2021 Nortek Security & Control LLC . All rights reserved .
Mighty Mule is a registered trademark of Nortek Security & Control LLC .
Mighty Mule Sales: 800-543-4283 | Mighty Mule Technical Support: 800-543-1236 • Mon-Fri 8am - 7pm EST • Saturday 10am - 6:30pm EST
5919 Sea Otter Place, Carlsbad, CA, 92010
www .mightymule .com
Keypad Specifications
Frequency
318MHz from keypad to gate opener
900MHz from keypad to base station
Memory - Keypad
Stores up to 25 four digit entry codes
Power Consumption – Keypad
60 ma when relay is closed
Power Supply – Keypad
8-24vdc or four AA batteries
Power Supply – Base Station
9 vdc 300ma transformer; 3 .6V Ni-MH 800ma rechargeable battery pack
Range from keypad to base station
500’ wireless
Range from keypad to gate opener
50’ wireless 100’ wired using 16 awg wire
Relay Output – Keypad
Momentary, dry, normally open contact closes for 2 seconds upon activation
Relay Output Rating – Keypad
12 or 24vdc 100ma
Wiring – Base & Keypad Antennas
RG6 or RG59 Coaxial Cable
Wiring – Keypad Power & Relay Output
16 awg stranded low voltage direct burial wire
10022727 Rev-B
