14
Adding Additional Base Units
Batteries must be installed and the units turned ON .
1 . Press and release the “ID SET” button on the Keypad .
2 . Press the number on the Keypad that corresponds to the
Intercom you are adding or changing . You will hear the
number of beeps corresponding to the number you pressed .
For Example:
If you are adding a third base unit to the
system PRESS #3 . The keypad will beep THREE times .
3 . Press the “ID SET” button on the base unit until it beeps
then release . You will hear beeps from the base unit and
beeps from the keypad, which means the ID Codes are set .
IMPORTANT:
Place Intercoms through the home or office with
at least 10 feet between them to prevent interference .
RELAY
OUTPUT
AC/DC
POWER IN
1 2 3 4 5 6 7 8 9
+
0
–
ID SET
+
–
–
– +
+
–
+
RESET
JUMPER
ID SET button
ID SE
T
VO
LUM
E
POWE
R
O
FF
O
N
Keypad - Inside
Intercom - Bottom
1
2
ABC
3
DEF
4
GHI
5
JKL
6
MNO
7
PRS
8
TUV
9
WXY
0
CALL
STATUS
PROGRAM
CALLING
GRANTED
Keypad - Front
ID SET button
Intercom ID Codes
The Base and Keypad that came in this kit are programmed at the factory to communicate with each other, and do not need the ID
Codes programmed . This Base is the MASTER or #1 unit .
If you have purchased additional Base units to enhance your
system, each additional unit’s ID Code must be programmed into
the Keypad so they can communicate . Follow the steps below to
set the ID codes .