Problem solving guide
86
Fault messages after a programme has been cancelled
Problem
Possible cause and remedy
Water intake fault.
Turn on the tap.
The water inlet is blocked or restricted.
Check whether the tap is turned on properly.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
Check whether the maximum delivery height of
1 m has been exceeded.
Waterproof system
activated. Turn off
the tap. Call Miele.
The water protection system has reacted.
Turn off the tap.
Call Miele.
Fault F. If restart
fails, call Miele.
There is a fault.
Disconnect the washer-dryer from the electricity
supply. Switch off at the wall and withdraw the
plug from the socket, or switch off the mains
circuit breaker.
Wait
at least 2 minutes
before reconnecting the
washer-dryer to the electricity supply.
Switch the washer-dryer back on.
Restart the programme.
If the fault message appears again, contact Miele.
To switch off the fault message, switch the washer-dryer off with the
sensor.
Содержание WTW 870 WPM
Страница 126: ......
Страница 128: ...M Nr 11 976 031 01 en AU NZ WTW 870 WPM ...