Miele SmartLine CSDA 7000, Инструкции по эксплуатации и монтажу

Страница: 61 / 72

Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
61
Preparing the worktop
 Create the worktop cutout. Remem-
ber to maintain the minimum safety
distances (see “Installation – Safety
distances”).

Seal any cut surfaces on wooden
worktops with a special varnish, sil-
icone sealant or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
 For wooden worktops, secure the
wooden frame 5.5 mm below the up-
per edge of the worktop.
For CS 7611 FL, the wooden frame
must be secured 7 mm under the up-
per edge of the worktop.
Fitting the spacer bars
Use the middle screw holes if one of the
following SmartLine elements is in-
stalled to the right or left of the spacer
bar: CS 7611, CS 7641, CS 7101(-1),
CS 7102(-1)
Wooden worktops
 Position the spacer bars flush onto
the lower step of the stepped cutout.

Secure the spacer bars with the
3.5 x 25 mm wood screws supplied.
Natural stone worktops
You will need heavy-duty double-
sided tape (not supplied) to secure the
spacer bars.
 Stick the tape onto the lower step of
the stepped cutout.
 Position the spacer bars flush onto
the lower step of the stepped cutout.

Press the spacer bars firmly into
place.