Changing the door hinging
95
Remove cover
and refit on the op-
posite side.
Turn holder
through 180° and
screw it into position in the two op-
posite slots in the hinge plate.
Secure hinge plate
on the opposite
side, starting with screw
in the
middle at the bottom.
Then screw in the other two
screws
.
Insert hinge pin
complete with
washer and adjusting foot.
Important. The lug on the hinge pin
must point to the back again.
Changing the middle hinge
plate over
Pull off cover
.
Unscrew hinge plate
with the pro-
tective film underneath.
Turn hinge plate
through 180° and
screw it with the protective film into
position on the opposite side.
The protective film protects the appli-
ance housing from damage.
Turn grey plastic cover
through
180° and refit it in the hinge plate.
Tip:
Plastic cover
fits over the pro-
truding bearing bush so that this is
covered from underneath and from the
side.
Turn cover
through 180° and refit it
on the opposite side.