Miele DGC7440W, Инструкции по эксплуатации и монтажу

Страница: 154 / 172

Problem solving guide
154
Problem Possible cause and remedy
The sensors do not
respond. You have selected the Display | QuickTouch | Off setting.
Therefore, when the steam oven is switched off, the
sensors do not respond.

As soon as the steam oven is switched on, the
sensors will respond. If you want the sensors to
always respond even when the steam oven is
switched off, select the
Display | QuickTouch |
On
setting.
The steam oven is not connected to the power
supply.
 Check that the steam oven plug is correctly
inserted into the socket.

Check if the circuit breaker has tripped. Contact a
qualified electrician or Miele.
There is a fault with the control unit.

Touch and hold the On/Off

sensor until the
display switches off and the steam oven restarts.
A humming sound can
be heard during
operation and after
switching off the steam
oven.
This noise does not indicate incorrect operation or an
appliance fault. The noise is made by water being
pumped through the system.
After moving house, the
appliance no longer
switches from the
heating-up phase to the
cooking phase. Altitude affects the boiling point of water. If you move
house, the appliance will need to be reset for the new
altitude if this differs from the old one by more than
300 m.
 To adjust the boiling temperature, you need to
descale the appliance (see “Cleaning and care –
Maintenance”).
During operation an
unusually large amount
of steam escapes or
steam escapes from
parts of the steam oven
where it does not
usually. The door is not properly closed.
 Close the door.
The door seal is not correctly fitted.

If necessary, press it in all the way round the door
to make sure it is fitted evenly.
The door seal is damaged, e.g. cracked.

Replace the door seal.
This can be ordered from Miele (see the end of this
booklet for contact details).